Field-controls STARKAP SK-1 Manual do Utilizador descarregar pdf (Página 3)

Page 3

INSTALLATION

1. Before installation, apply two beads of high temperature

silicone sealant or equivalent around the bottom of the storm

collar and 1 inch above the end of the Starkap™ body. (See

Figure 2)

2. Insert the Starkap™ into the inside of the vent termination

pipe, making sure the Starkap™ is seated against the storm

collar. Fasten the Starkap™ to the vent termination pipe by

using three (3) sheet metal screws. Placement of the screws

should be approximately 1/2 inch from the end of the vent termination pipe. (See Figure 3) The

heads of the screws should be covered with high temperature.

Figure 2

Figure 3

1 2 3 4 5 6 7 8 ... 11 12

Sem comentários

Field-controls STARKAP SK-1 Manual do Utilizador Página 3